Do not adjust wick as it has been preset.
Remove lens.
Attach cap and wick assembly on base lamp.
Allow 2 - 3 minutes for wick to draw oil before lighting the lamp.
Replace lens to fit securely on the base in an upright position.
Carefully remove wick from lamp, torch or lantern and fill with appropriate filling equipment such as a small funnel or a squeeze bottle with tube nozzle. Ensure that the wick is 3-5mm visible. The more visible the wick, the higher the flame. The higher the flame, the brighter the light. Keep wick short to avoid excessive burning. Excessive burning reduces burning hours. A 3-5mm wick will burn for 80 hours. Allow new wick 5 minutes to absorb oil. Avoid spillage and wipe off any excess before lighting.
Use in well-ventilated area.
Carefully remove wick from torch, lamp or lantern and fill with appropriate filling equipment such as a small funnel or a squeeze bottle with tube nozzle. Ensure that the wick is more than 10mm visible. The more visible the wick, the higher the flame. The higher the flame, the more visible the smoke. Keep wick short to avoid excessive smoke. Allow wick 5 minutes to absorb oil. Avoid spillage and wipe off any excess before lighting. Use in a well-ventilated area.
The length of the wick, at the flame end, should be adjusted that the flame is not too big. (±3-5mm). Pull down gently if required. Always use a wick that has been folded double. For best results, maintain the oil level above the two third mark. Clean lamps regularly with warm soapy water. Do not use any chemicals or boiling water to clean the base, as it can cause damage. ONLY USE @delight oils
Direct contact between the lens and the flame will damage the lens.
When an oil discharge is noticed from the cap and wick assembly, the cap should be loosened once to release pressure build-up.
Handle with care.
Refer to your supplier for spares.
LAMP WICK AND CAP SINGLE
Screw cap onto lamp. Adjust wick 3-5mm.
Allow 5minutes for wick to absorb oil.
Now light wick. Cover flame with shade.
LAMP WICK SINGLE 3MM X 30CM
Form a loop with wick and line.
Pull line and wick through cap.
Adjust wick 3mm and then remove line.
Cnr 45 Wimbledon and Sysen Road,
Blackheath, Cape Town, 7580
Western Cape, South Africa
Email: info@delightslamps.co.za
Email: marelize@caprichem.com
Phone: +27 (021) 905 4712
SHARE THIS PAGE!